|
|
#1
2nd August 2010, 10:47 PM
|
||||
|
||||
Gearbox mounting bolt sizes
Anyone know how many and what size/thread bolts are used for a type 9 gearbox to zetec??
Need to get myself a handful 
__________________
~ My Build Diary - http://davesroadster.blogspot.com/ *updated 7/6/11* Best bit so far: Getting it running Worst bit so far: Cutting steel for wishbones and engine mounts. Most annoying bit so far: Generator packing up half way through welding. Last edited by David_17 : 3rd August 2010 at 10:17 AM. 
|
|
#2
3rd August 2010, 10:17 AM
|
||||
|
||||
|
Anyone?
__________________
~ My Build Diary - http://davesroadster.blogspot.com/ *updated 7/6/11* Best bit so far: Getting it running Worst bit so far: Cutting steel for wishbones and engine mounts. Most annoying bit so far: Generator packing up half way through welding.
|
|
#3
3rd August 2010, 03:00 PM
|
||||
|
||||
Only me
Just popped in to catch up on some of the recent posts & noticed this
I have just had a look on my engine ( I used the original Zetec bolts ) They are M10 X 40mm set bolts ( Fully threaded bolts ) standard metric thread. One difference over a standard M10 set bolt is that the head size is reduced to take a 13mm spanner .... I believe there is still enough room for a 17mm standard hex head though  If memory serves me right, 6 bolts will do the trick. Hope that helps Dave
__________________
I am not a complete idiot...........Some of the parts are missing !! Ronnie www.roadster-builders.co.uk
|
|
#4
3rd August 2010, 03:05 PM
|
||||
|
||||
|
Great. Thanks ronnie.
Welcome back. Will you be staying around?
__________________
~ My Build Diary - http://davesroadster.blogspot.com/ *updated 7/6/11* Best bit so far: Getting it running Worst bit so far: Cutting steel for wishbones and engine mounts. Most annoying bit so far: Generator packing up half way through welding.
|
|
#5
9th August 2010, 06:59 PM
|
|||
|
|||
|
bolts
beware some earlier posibly kent engined 4 speed bellhousings had UNC a thread that looks like M10 but will break bell housing so clean the thread out cafully dont force the bolts and you will be fine all later bellhousings are fine and deffinatly M10 hope this helps.
|
|
#6
9th August 2010, 07:08 PM
|
||||
|
||||
|
There was a slight clue in the word ZETEC
 Metric only on the Zetec engine
__________________
I am not a complete idiot...........Some of the parts are missing !! Ronnie www.roadster-builders.co.uk
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
