|
|
#1
19th October 2010, 09:02 PM
|
||||
|
||||
Heatproofing cables
My starter cables run too close for comfort to my exhaust, and i want to wrap, or cover them with something.
Anyone got any simple solutions?  Cheers Dave
__________________
~ My Build Diary - http://davesroadster.blogspot.com/ *updated 7/6/11* Best bit so far: Getting it running Worst bit so far: Cutting steel for wishbones and engine mounts. Most annoying bit so far: Generator packing up half way through welding. 
|
|
#2
19th October 2010, 09:07 PM
|
||||
|
||||
|
Fibreglass sheet! You can easily obtain it from any hotel
__________________
1.8 Silvertop Zetec (ZX6R Carbs + Megajolt) + Type 9 My Build Blog: http://www.haynes.co.uk/forums/showthread.php?t=2736 - Last Update: 31st October 2020 Total Spent so far: Stopped counting 
|
|
#3
19th October 2010, 09:31 PM
|
||||
|
||||
|
You've lost me..
__________________
~ My Build Diary - http://davesroadster.blogspot.com/ *updated 7/6/11* Best bit so far: Getting it running Worst bit so far: Cutting steel for wishbones and engine mounts. Most annoying bit so far: Generator packing up half way through welding.
|
|
#4
19th October 2010, 09:37 PM
|
||||
|
||||
|
Fire blanket
 I expect you can get some silicone sleeving .... The kind of stuff that is often found protecting Lambda sensor cables, those little devils are often in very close proximity to the exhaust system
__________________
I am not a complete idiot...........Some of the parts are missing !! Ronnie  www.roadster-builders.co.uk
|
|
#5
20th October 2010, 08:31 PM
|
|||
|
|||
|
CBS sell it in different diameters in 1m lengths, im just addressing the same probs myself with starter cables being very close to my manifold.
Im heat wrapping a small piece of the manifold near the cables and putting heat sleeving over the cables for good measure.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
