|
|
#1
28th January 2011, 06:35 PM
|
||||
|
||||
Aluminium prices
Just been pricing up ali for floor, rear bulkhead and side tunnel. For 2.0mm floor and 0.9 for the rest came to around 125 quid delivered and cut roughly to size. Is this OK, or can anyone recommend somewhere cheaper.
Also, the website didn't state what grade, so will have to investigate further. If I'm using total GRP bodywork, is this all I'll need? (2x floor panels, 3x tunnel parts and the rear bulkhead) or am I missing something. Alan 
|
|
#2
28th January 2011, 06:53 PM
|
|||
|
|||
|
Use one sheet to do the floor and cover the bottom of the trans tunnel..3 bits for tranny tunnel 1 bit for seat bulkhead but seat doodah could be done in 2 bits if easier on material if you get my drift?
As for price I have no idea these days but would expect not cheap as ali never was 
|
|
#3
28th January 2011, 07:19 PM
|
|||
|
|||
|
Guess i got a bargain today then ? 2800x 1400 3.0 mm ali for £60 ?
 Marked out looks like i have enough for the floor rear bulkhead trans tunnel
__________________
theres a box ! im not allowed in it ! i have to think outside !
|
|
#4
29th January 2011, 10:09 AM
|
||||
|
||||
|
that sounds damn cheap, where's that from?
|
|
#5
29th January 2011, 05:02 PM
|
|||
|
|||
|
its from my local scrap yard ! i try to visit every friday and they had some old signage in from a local hotel (similar size to petrol station price display)
2800mm x 140mm x3 mm so my floor can come out of the first meter  pretty much everything on my build has been recycled i dont think ive bought anything new apart from my chassis kit but when you think of it thats probably been something else before andy bought it and cut it up oh and the wishbones from saturn
__________________
theres a box ! im not allowed in it ! i have to think outside !
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
