|
|
#1
12th September 2011, 11:15 AM
|
||||
|
||||
Fuel Sender Sealant/Glue?
What sort of sealant/glue would be good use to attach and seal the electrical plug for the fuel sender to a 1mm steel plate?
|
|
#2
12th September 2011, 12:19 PM
|
||||
|
||||
|
Been digging and came across zap z-poxy (http://www.axminster.co.uk/zap-z-pox...sin-prod23719/) just wondering if this stuff is ok to use? Is there any difference between this stuff and more generic epoxy's that are alot cheaper? Is there something better to use?
|
|
#3
13th September 2011, 09:36 AM
|
||||
|
||||
|
Nobody able to advise on the use of epoxy adhesives with fuel?
|
|
#4
13th September 2011, 09:54 AM
|
||||
|
||||
|
Maybe not epoxy based glue as it would be a bugger to remove afterwards. Pro-Seal do a range of Silicone based "Instant Gasket":
http://www.supergluecorp.com/pro-sea...-gasket-makers Certain colours for differents applications, the black one would be suited to the fuel tank sender. Have used them quite a bit with no issues. Your local motor factors may have them in stock. AndyH
__________________
Haynes Roadster / Saturn GRP Bodywork. Now available direct through http://www.gillhamonline.co.uk/ or contact me direct on andrew.hugill@ntlworld.com Regards..........AndyH
|
|
#5
13th September 2011, 12:03 PM
|
||||
|
||||
|
Thanks spud, so would that stuff also work as an adhesive as I need it to hold it in place as well as seal it?
|
|
#6
13th September 2011, 12:53 PM
|
||||
|
||||
|
No i wouldn't use it as an adhesive, self tapping screws would be the choice if you can.
__________________
Haynes Roadster / Saturn GRP Bodywork. Now available direct through http://www.gillhamonline.co.uk/ or contact me direct on andrew.hugill@ntlworld.com Regards..........AndyH
|
|
#7
13th September 2011, 01:47 PM
|
||||
|
||||
|
Hmm not sure that will work as its only the small cylinder electrical plug that I need to attach and seal somehow. I currenlty just have a small hole drilled which it sits in but it doesn't exactly stay in the hole that well. Maybe I do just attach it permanently then and if it ever goes or I upgrade my tank I just replace the sender and the small plate I've attached it to?
|
|
#8
13th September 2011, 01:57 PM
|
||||
|
||||
|
Quote:
__________________
Haynes Roadster / Saturn GRP Bodywork. Now available direct through http://www.gillhamonline.co.uk/ or contact me direct on andrew.hugill@ntlworld.com Regards..........AndyH
|
|
#9
13th September 2011, 03:20 PM
|
||||
|
||||
|
Nice one, thanks for your help
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
