#1
|
|||
|
|||
Help with tt9 and tt11
Hi.
I think I am being a bit dim but I am confused about tt9 and tt11. The book shows 3 different angles to cut but surely there can be only 2. One on the horizontal axis and one on the vertical? Thanks for any enlightenment:-) |
#2
|
||||
|
||||
Hi,
It may be too late to reply to this post, and you certainly figured it out by yourself, but just in case: - the 2 angles to consider are (for TT9), 12° (vertical angle, TT9 will be at 12° from the horizontal plan) and 14.5°, horizontal angle (TT9 will be at 14.5° from the vertical plan). 12.5° is not a cut angle, it is just a "view" : how the angle of this face looks like after the 2 cuts when you look at the tube from the side, at 14.5°. I don't know if I'm clear, but I hope this will help. Good luck. Sylvain
__________________
Sylvain Pictures of my completed Roadster https://www.flickr.com/photos/994983...7646799525542/ Build blog: http://vouchtroadster.blogspot.se/ https://cafrazx550.blogspot.com/ |
#3
|
|||
|
|||
Thanks for the reply. I did figure it out in the end exactly as you say.
I was overthinking it ;-) |
Thread Tools | |
Display Modes | |
|
|