#1
|
|||
|
|||
Pedal box/Brake cylinder
Hi all.
I am building the pedal box but the drawing on page54 dont show the height of the hole for the master brake cylinder. It looks like it is about 40mm. But If i draw a strait line from the pushrod hole in the pedal it will go down like 15mm. Is there anyone out there having foto/suggestiens of this. And i also whant to build it with the original angle on the master cylinder like Bonzo did, but i dont think that will make any differens on the height. Peter.
__________________
http://www.flickr.com/photos/swe7/ |
#2
|
||||
|
||||
Hi,
Are you using a Sierra or another car master-cylinder ? If you are using a Sierra M/C, 30mm above the lower edge of the plate leaves enough room for a 8mm bolt/nut on the lower fitting hole. Hope this will help.
__________________
Sylvain Pictures of my completed Roadster https://www.flickr.com/photos/994983...7646799525542/ Build blog: http://vouchtroadster.blogspot.se/ https://cafrazx550.blogspot.com/ Last edited by voucht : 29th July 2012 at 06:21 PM. |
#3
|
|||
|
|||
Quote:
Thank you. Peter.
__________________
http://www.flickr.com/photos/swe7/ |
Thread Tools | |
Display Modes | |
|
|