|
|
#1
31st December 2012, 10:51 AM
|
|||
|
|||
inlet manifold
Does anyone know what the thread size of the take off from the inlet manifold for the vacuum on the brake servo on a 1.8 cvh is, as I'm wanting to block this off with a blanking plug.
Many thanks
__________________
Richard Just keep going we will get there in the end. 
|
|
#2
31st December 2012, 08:09 PM
|
|||
|
|||
|
I think you will find its either 1/8th or 1/4 n.p.t. If you look in europa spares they do them. I need one for my low profile manifold for the vacum and one to block off t.he water to the heater as it wont be worth fitting a heater.
Arfon
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
