#101
|
||||
|
||||
Well again a newbie question here but is the ignition switch the same as barrel where the key goes in or is somewhere else on the loom? I guess we've proved by testing the voltages on the plug (not the barrel) are the same as the barrel so I would have thought the problem is somewhere else in the loom?
|
#102
|
|||
|
|||
Has the ignition barrel been off or dismantled or any part of the assembly been apart. Also was the donor a runner when you got it ie,on the button.
__________________
When The Results Disagree With The Theory: Believe The Results And Invent A New Theory If I had two brains I,d still be a halfwit The cave http://s1116.photobucket.com/user/my...deshow/mancave The build http://www.haynes.co.uk/forums/showthread.php?t=12669 |
#103
|
||||
|
||||
The ignition barrel/assembly hasn't been touched for what i can tell I can tell but I'm a bit of a newbie that way. It was just unplugged when I took the loom out. It just looked like the yellow/black wire was cut at some point in the past before me as it was joined up with a terminal block when I took it apart. The donor was indeed running as I drove it home because I didn't have means to move a non-runner.
|
#104
|
||||
|
||||
Ignition switch is on the oposit end of the barrel from the key.
TT
__________________
You only get a woosh with a dump valve Build Thread Man Cave Mantiques Cecil Street Auto Repairs Garage Carlisle Build Cost £4181.65 - Last - Wheel Cylinders |
#105
|
||||
|
||||
Ok so that rules that out I guess. Where do I go next to try and get it running? Do you think I need to connect the ecu?
|
#106
|
||||
|
||||
We need to figure out waht's wrong with the loom. Did you check the voltages with the switch unplugged?
TT
__________________
You only get a woosh with a dump valve Build Thread Man Cave Mantiques Cecil Street Auto Repairs Garage Carlisle Build Cost £4181.65 - Last - Wheel Cylinders |
#107
|
||||
|
||||
Yes, they where the same as with it plugged in.
|
#108
|
||||
|
||||
I've been trying to read the wiring diagram and it looks like there should only be two wires on the ignition switch on the 1.6/1.8 cfi's. A red and yellow/black. It looks like the yellow/black should to to the anti-theft module (which I don't think I have), then it also seems to split and go to 1) power delay relay as a black wire? 2) ecu as a black wire [pin 5] 3) edis as a black wire [pin 8]. The red wire coming out of the ignition on the other had appears to split also and go to an engine managment relay, the battery positive, the ecu via a fuse [pin 1], and the power delay relay. Is the problem something like because I don't have the ecu plugged in, it's not completing the circut and i need to cut the ecu wires off and connect them up to each other?
|
#109
|
||||
|
||||
Ok. Have you found the alarm module and it's black/Yellow wires. Unplug the module and test the voltage at the ignition again.
Also test the continuity between the starter wire at the starter and the blue/black at the switch. Have you managed to find the matching wires for the coil? TT
__________________
You only get a woosh with a dump valve Build Thread Man Cave Mantiques Cecil Street Auto Repairs Garage Carlisle Build Cost £4181.65 - Last - Wheel Cylinders |
#110
|
||||
|
||||
Quote:
Quote:
Quote:
|
Thread Tools | |
Display Modes | |
|
|