#131
|
||||
|
||||
Any progress in the last 3 months?
TT
__________________
You only get a woosh with a dump valve Build Thread Man Cave Mantiques Cecil Street Auto Repairs Garage Carlisle Build Cost £4181.65 - Last - Wheel Cylinders |
#132
|
||||
|
||||
Any Progress in the last 8 months?
TT
__________________
You only get a woosh with a dump valve Build Thread Man Cave Mantiques Cecil Street Auto Repairs Garage Carlisle Build Cost £4181.65 - Last - Wheel Cylinders |
#133
|
||||
|
||||
I presume this build is dead as we haven't heard anything for nearly 2 years, shame
|
#134
|
||||
|
||||
Quote:
I supplied the chassis for this build but haven,t heard anything either, shame, cheers andy
__________________
Flat Pack Chassis Kits for sale, contact me at andyroadster@yahoo.co.uk |
#135
|
|||
|
|||
I would guess, that given his last post on here was for ideas on how to get the drive to the front wheels, that the cost of a bespoke gearbox has put paid to this project.
TK
__________________
Innovation not Imitation!
|
#136
|
||||
|
||||
I could never see how it was going to work , be IVAable and look ok.
TT
__________________
You only get a woosh with a dump valve Build Thread Man Cave Mantiques Cecil Street Auto Repairs Garage Carlisle Build Cost £4181.65 - Last - Wheel Cylinders |
#137
|
||||
|
||||
I had my doubts
|
#138
|
|||
|
|||
The challenge is at the front. The lump of transferbox that will intrude into the cockpit is far enough back to not be a problem, it basically ends up under your knees which are bent anyway. the shaft going forward is inside the tunnel long before it gets to the pedals so thats not an issue. Then comes the front. The way i saw it was the the diff has only one place to go so thats where the steering rack will end up and the driveshafts would have to go through where the front springs go. So it would have to be cantilever springs and shocks mounted inboard and that then that just leaves the steering rack. The only way I could see a route for the steering column to get to the steering rack would be one of those steering angle drives like the ones used on forward control small commercials . The rack could then be mounted with the spline looking straight up and the column could point over the top of the halfshaft then change direction via the miter box. Simples
http://www.google.co.uk/imgres?q=ste...r:2,s:0, i:69 If I had more time I would relish the challenge Bob
__________________
When The Results Disagree With The Theory: Believe The Results And Invent A New Theory If I had two brains I,d still be a halfwit The cave http://s1116.photobucket.com/user/my...deshow/mancave The build http://www.haynes.co.uk/forums/showthread.php?t=12669 Last edited by robo : 14th April 2012 at 08:45 PM. |
#139
|
||||
|
||||
I guess this is why Ford running gear is suggested is best, i did think it was a difficult way to go.
Shame still, be good to know what happend though. wolly |
#140
|
||||
|
||||
My approch would be to go with an Impreza engine,gear box and uprights,push the engine as far forward as possible putting the drive shafts in front of the bulk heads. I think we had this conversation two weeks ago?
__________________
Website http://www.talonmotorfabrication.co.uk/ Direct email phil@talonmotorfabrication.co.uk talonmotorfabrication@gmail.com Mobile office hours 07514098334 |
Thread Tools | |
Display Modes | |
|
|