![]() |
#131
|
|||
|
|||
![]() ![]() Rear lower ![]() Front lower ![]() These were quiet time consuming but very satisfying to make ![]()
__________________
Slowly tipping over the edge into madness |
#132
|
|||
|
|||
![]() ![]() Getting the engine and gearbox in place ![]() ![]() ![]() engine mounts tacked up gearbox mount also done
__________________
Slowly tipping over the edge into madness |
#133
|
|||
|
|||
![]() ![]() Front suspension in place ![]() ![]() ![]()
__________________
Slowly tipping over the edge into madness |
#134
|
|||
|
|||
![]() ![]() Wheels on ![]() ![]() View from the door
__________________
Slowly tipping over the edge into madness |
#135
|
|||
|
|||
![]() great work it feels really good when you can sit her on wheels doesn't it ? for now I used a length of wood with a hole top and bottom instead of shocks at least you can then wheel it back and fore
__________________
remember we are not mad just creatively insane |
#136
|
|||
|
|||
![]() Yea feels like a major milestone.
Ive used 25mm box in place of the shocks at the moment. Did people find the rear upper wishbones too short on the saturn plans.
__________________
Slowly tipping over the edge into madness |
#137
|
|||
|
|||
![]() haha yes I had to redo them as I had massive negative camber on the back, if I remember right I shortened the lowers and have spacers to bring the wheels out
__________________
remember we are not mad just creatively insane |
#138
|
|||
|
|||
![]() I think i have enough meat on the upper wishbone to drill another further out so will give that a try first
__________________
Slowly tipping over the edge into madness |
#139
|
|||
|
|||
![]() How have you mounted the gearbox?
|
#140
|
|||
|
|||
![]() Hope these are helpful
![]() ![]() ![]() ![]() the mount is an engine mount from the engine
__________________
Slowly tipping over the edge into madness |
![]() |
Thread Tools | |
Display Modes | |
|
|