Rosco's haynes Build

[Rosco]

A bit of an update tonight, I was looking on speedhunters today like I do most days, and they decided to do a little wright up with some pictures I sent in

http://www.speedhunters.com/2015/03/...owered-builds/

It's about half way down

Next on the list, the lathes all finished



Also I'm back on my pedal box, should get it all tacked up this week



Clamping the sides up square

[Rosco]

Pedals





Flange bearings for the pivots



All the tubes will be tig welded in

And that's it for now

[dubzter]

that pedal box looks amazing, keep up the good work

[Tatey]

Lathe and pedal box are looking good Ross!

One quick question, it's probably the angle of the photo, but will you be able to fit a cap head to the bottom master cylinder mounting holes as the brackets look a little close?

[metal matt]

Now that is a fine bit of fabrication if I do say

[Rosco]

Originally Posted by dubzter

that pedal box looks amazing, keep up the good work

Originally Posted by Tatey

Lathe and pedal box are looking good Ross!

One quick question, it's probably the angle of the photo, but will you be able to fit a cap head to the bottom master cylinder mounting holes as the brackets look a little close?

Originally Posted by metal matt

Now that is a fine bit of fabrication if I do say

Cheers for the comments, it's going well at the min!

Yeah there's just room for a bolt

[Rosco]

A bit more done tonight, I made some exhaust hangers at the weekend and my rubber mounts came today so got it all mounted and tacked up









Pretty happy with how it's worked out, sits where I want it to which in good

[flyerncle]

Porn in metal that pedal set,shame it wont be seen.

[Rosco]

Had a good few days on the car this weekend, got a bit done

Pedal box tacked up and in the car, there's still a bit to do on it but at least I no where my seats going







Front seat rails done, I've raised the front of the seat to lower the harness holes at the rear

[Rosco]

Nuts welded underneath



Harness mounting bosses made