|
|
#141
17th November 2016, 10:22 PM
|
|||
|
|||
This may be the last update on this site
Quiet sad really Ok so here is where im at  Untitled by stephen harborne, on Flickr Untitled by stephen harborne, on FlickrThis is what i have removed from the original loom Havnt had a lot of time since ive been back from holidays but been tipping awayat the wiring
__________________
Slowly tipping over the edge into madness 
|
|
#142
18th November 2016, 01:37 PM
|
|||
|
|||
|
Don't throw any of it away until you are finished I remember only to well the headaches doing the wiring just keep at it and you will get there
__________________
remember we are not mad just creatively insane
|
|
#143
18th November 2016, 02:16 PM
|
|||
|
|||
|
Yea its all away in a box for future use.
The wiring doesnt bother me at all i have it all connected back now to see if it still runs then hopefully take it all back out and crack on withe the chassis just have to get an engine crane to lift engine out.
__________________
Slowly tipping over the edge into madness
|
|
#144
18th November 2016, 11:46 PM
|
||||
|
||||
|
been at that stage for 24 months LOL... and I have a reasonably good understanding of sierra wiring
 TT
__________________
You only get a woosh with a dump valve Build Thread Man Cave Mantiques Cecil Street Auto Repairs Garage Carlisle Build Cost £4181.65 - Last - Wheel Cylinders
|
|
#145
21st November 2016, 10:09 PM
|
|||
|
|||
|
https://youtu.be/yeAGCuPd5FQ
so the engine still runs since i removed all the wires
__________________
Slowly tipping over the edge into madness
|
|
#146
8th January 2017, 10:08 PM
|
|||
|
|||
|
Hi All and happy new year
I spent a good bit of time over christmas grinding and cleaning down about the chassis To say it is a tedious job is an understatement but it is getting there slowly but surely  Untitled by stephen harborne, on Flickr Untitled by stephen harborne, on Flickr
__________________
Slowly tipping over the edge into madness
|
|
#147
8th January 2017, 10:17 PM
|
|||
|
|||
|
Also over christmas i got some of the parts i need for the steering
 Untitled by stephen harborne, on FlickrSo i got cracking on that to day which ment i had to put the engine back in the car to make sure the clearances were ok  Untitled by stephen harborne, on Flickr Untitled by stephen harborne, on Flickr Untitled by stephen harborne, on FlickrSteering column clearance
__________________
Slowly tipping over the edge into madness
|
|
#148
8th January 2017, 10:20 PM
|
|||
|
|||
|
__________________
Slowly tipping over the edge into madness
|
|
#149
8th January 2017, 10:32 PM
|
|||
|
|||
|
Nice to see you getting on
A couple of points there ain't a lot of rom between the steering extension ad the alternator Re the scuttle I think I have the measurements but the best way is to stick the nose on mark rear edge on top rails add bonnet then scuttle that way you know it's right will have a look on laptop later and se if I still have that info Gary
__________________
remember we are not mad just creatively insane
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
