Steveh1's build

[garyt]

hi steve cant find the pics I took but this is the relevant text that I did for Richard;
Right measuring back from the front edge of FF4 , the front return edge is 109cm back, and the rear bottom corner of the scuttle is in line with the front edge of U5
gary

[garyt]

looking at your pic with the alternator its the plug and wiring that get close to the shaft, also had to relieve my plenum support a tadge for piece of mind

[SteveH1]

Cheers thanks for that
Its actually lower than it looks in the pic and the support isnt in place but should be ok
Thanks

[SteveH1]

Got a bit more fabricating done

Handbrake cable mounting

Untitled by stephen harborne, on Flickr

Untitled by stephen harborne, on Flickr

Brake pipe mountings

Untitled by stephen harborne, on Flickr

Untitled by stephen harborne, on Flickr

[SteveH1]

I started doing some metal turning classes before christmas and have been making some stuff for the car

Earth points

Untitled by stephen harborne, on Flickr

Headlamp supports

Untitled by stephen harborne, on Flickr

Untitled by stephen harborne, on Flickr

Steering column tube

Untitled by stephen harborne, on Flickr

[chris_smith]

That's great work Steve, and helpful to my build as I'm about to start in handbrake location thanks

[SteveH1]

Originally Posted by chris_smith

That's great work Steve, and helpful to my build as I'm about to start in handbrake location thanks

Thanks
I did move it over and forward from the position in the saturn plans so i can use the cables without having to change the length of them
Also i think it was just in an awkward position in those plans aswell

[Mking]

Your build looks great. The pictures of the wishbones are a great help. I am scratching my head about those at the moment and the Saturn plans I have are confusing me quite a bit. I hope that it will all become clear once I start making the jig and piecing parts together.

[SteveH1]

Anybody know what the outside diameter of the protech front springs are
Thanks

[alga]

They're 1.9" ID nominal. The front 350 lb/in ones are 68mm OD, the 250 lb/in ones are 65mm OD.