![]() |
#11
|
|||
|
|||
![]() Yep and br10 inside br 3+4
|
#12
|
||||
|
||||
![]() Now I could be wrong but the only way I can see BR1 & 2 needing to be shorter and BR8 & 9 needing to be longer but still keeping BR7 the correct length is if somehow the distance across BR10 has increased.
I am probably way of the mark. I will wait for the picture before passing any more comment. We will get it sorted. Cheers Ginge
__________________
Sent from my iPad, from who knows where in the world I was building but I am not now! ![]() Build Pictures Build Thread |
#13
|
|||
|
|||
![]() I haven`t got my book to hand but I seem to remember I had a similar issue with some measurements, turned out I was measuring the mitred tubes wrong as in the length when mitred instead of before they were cut? I hope that makes sense? Dennis.
|
#14
|
|||
|
|||
![]() Thanks to Eon for the power cut at my parents for the last 2 days on and off. Now I'm on some slowwwwww mobile dongle thingy at mine. These pics will take ages for me to upload. Shocking focus on my phone aswell!
![]() ![]() Last edited by Rik178m : 8th February 2010 at 08:45 PM. |
#15
|
||||
|
||||
![]() How well does BR7 fit in between the BR8/9? If cut to the book length that it should fit perfectly, if it's too big for the gap then I think it means you have the large angles of BR8/9 wrong, I had them wrong when i made mine, they were about 1 degree out but mess up the entire section so i had to grind them out and redo them.
__________________
1.8 Silvertop Zetec (ZX6R Carbs + Megajolt) + Type 9 My Build Blog: http://www.haynes.co.uk/forums/showthread.php?t=2736 - Last Update: 31st October 2020 Total Spent so far: Stopped counting ![]() |
#16
|
|||
|
|||
![]() Haven't made BR7 yet but I've measured the gap and its bang on the same as BR7. Will measure the width is correct across FF tomorrow
|
#17
|
||||
|
||||
![]() put ff1 across the end it will soon become clear
![]() |
#18
|
|||
|
|||
![]() I've not put it on yet but the penny has dropped! Another school boy error!
Thanks mate |
#19
|
||||
|
||||
![]() Quote:
andy |
#20
|
|||
|
|||
![]() Hope so Think I have used the ouside edge of FF1 as the line for BR1+2. Going to check in half an hour
|
![]() |
Thread Tools | |
Display Modes | |
|
|