#11
|
||||
|
||||
two forms of immob are your ignition key and steering lock thats all you need. forget what the haynes book says its pants. just do it like it shows in the diagram sent you and everything will work as it should.
|
#12
|
|||
|
|||
Where do you store the baton though?...always bothered me that has
|
#13
|
||||
|
||||
Quote:
It may well be part of the immobiliser? Tried removing most of it (again hopefully). May find more stuff to make my day. If I short where the relay was, the engine turns when i turn the key as it should. So i'll fit a kill switch (HandyA) or just short it permanently??? Cheers for the feedback though. |
#14
|
||||
|
||||
Quote:
__________________
my build pics |
#15
|
||||
|
||||
Black and Yellow should not be grounded.
RED feed the ignition switch from the battery fused link. Black + yellow ( position 2 - engine run) Feeds some fuses and the ingnition relay. This is designated circuit 15-x ( x being sub-circuit numbers ) Don't confuse ignition with starting they are two seperate circuits Starting is circuit 50-x Which is black and Blue from the ignition switch to the inhibit/anti-theft relay and then black and blue to solder joint S-1039 which acording to the data is near the rear WashWipe motor loom where it becomes black and red untill the starter motor. TT
__________________
You only get a woosh with a dump valve Build Thread Man Cave Mantiques Cecil Street Auto Repairs Garage Carlisle Build Cost £4181.65 - Last - Wheel Cylinders |
#16
|
||||
|
||||
Quote:
also when you switch the key off, what happens to black/yellow then?
__________________
my build pics |
#17
|
||||
|
||||
When you switch the ignition switch off the +12V supply on the Black and Yellow is switched off but it's not grounded.
TT
__________________
You only get a woosh with a dump valve Build Thread Man Cave Mantiques Cecil Street Auto Repairs Garage Carlisle Build Cost £4181.65 - Last - Wheel Cylinders |
#18
|
||||
|
||||
ok, goood, thats what ive done. Now, its rturning over fully but not starting, the black/yellow is correct as when i put it on, theres 12v at pin 10 of the hybrid ignition module. ALso, in the auto trans relay did you say to short pins 86 and 87, as ive also shorted it to pin 30 on the relay to connect it to the starter solenoid?
__________________
my build pics |
#19
|
||||
|
||||
One Caviat..
On some of the injection engines, like the 2.9. A circuit ( 50-7 on the 2.9 ) is fed from the starter circuit during crank. In that case it goes to the TFi module and alters the timing advance to make the eninge start easier. But on the 1.8 Carbed CVH it's not present. TT
__________________
You only get a woosh with a dump valve Build Thread Man Cave Mantiques Cecil Street Auto Repairs Garage Carlisle Build Cost £4181.65 - Last - Wheel Cylinders |
#20
|
||||
|
||||
Quote:
__________________
my build pics |
Thread Tools | |
Display Modes | |
|
|