Steveh1's build

[SteveH1]

Finally got the engine back together mostly

Untitled by stephen harborne, on Flickr

Untitled by stephen harborne, on Flickr

[twinturbo]

Scrubbed up nicely

[bentovey]

Just read you entire build, great work!!
I’m just starting mine (mx5 just stripped)
Keep up the good work, and posts

[SteveH1]

So ive got a bit done recently
First i built an spacer for the new rear coolant pipe for the reroute to move it out from the block

Untitled by stephen harborne, on Flickr

Then i filled in the the hole in the side coolant connector

Untitled by stephen harborne, on Flickr

Used a 20 cent to stop the epoxy running into it

Untitled by stephen harborne, on Flickr

Filled with epoxy

Untitled by stephen harborne, on Flickr

The hole was a feed for the interior heater so is not needed

[SteveH1]

This is the coolant reservoir That i got
It only has this mounting point so i made a bracket to hold the whole thing

Untitled by stephen harborne, on Flickr

Untitled by stephen harborne, on Flickr

Untitled by stephen harborne, on Flickr

I also removed the old mounting points for the heat shield from the manifold and cleaned and painted it

Untitled by stephen harborne, on Flickr

[SteveH1]

I also started on the pedal box

Untitled by stephen harborne, on Flickr

I also mounted the ecu under the dash

Untitled by stephen harborne, on Flickr

And made a bracket for the accelerator cable

Untitled by stephen harborne, on Flickr

And the engine is back in

Untitled by stephen harborne, on Flickr

[SteveH1]

Next up was to mount the radiator to the chassis
I was originally going to use a spurious golf rad which was not great looking to be fair then coolex had nice ali rads for a polo for quiet cheap at the national kit car show so i picked one up

I Got two brackets bent up for it to mount it to the chassis

Untitled by stephen harborne, on Flickr

Clamped in place to check everything lines up

Untitled by stephen harborne, on Flickr

Checking the fit of the nose cone

Untitled by stephen harborne, on Flickr

I decided to add two new pieces to the chassis rather than drill through the existing chassis

Untitled by stephen harborne, on Flickr

[SteveH1]

Then i started on the piping for the cooling system which i picked some of it up at the kit car show
And some of the rest of the parts came from aliexpress
I picked up the wrong size pipe so i need to get some more 32mm id piping

Untitled by stephen harborne, on Flickr

Then i started on the wiring which is a whole other can of worms

Untitled by stephen harborne, on Flickr

Untitled by stephen harborne, on Flickr

[RandyBMC]

Wiring is one of my next big tasks. Are you going to shorten/remove unneeded pieces on the stock harness?

[SteveH1]

I have most of the unnecessary wiring stripped out now.
The car i stripped had almost every extra electronic thing available so i reckon i have about half of the origional wiring removed
I just needs lots of organising and adjusting.
If your gonna strip the unnecessary wiring make sure you have a good wiring diagram