#301
|
|||
|
|||
More done today, loads of bits and bobs to do, got my clutch cable sorted, had to make a bit at the pedal end and solder a bit on the other end, it wouldn't solder to start with, to hot I think, but got it done in the end.
Also got all my aluminium engine cradle spacers back on and tightened up. Then went down my dads and made my air filter backplate ready for the itg filter, I got a drawing from ITG for the outside Came out mint Pretty much there now, just need a few holes in it for wiring, air temp and the fuel feed, also need some 3mm spacers under the trumpets to replicate what was there before as it's got orings that seal everything |
#302
|
|||
|
|||
|
#303
|
|||
|
|||
|
#304
|
|||
|
|||
|
#305
|
|||
|
|||
|
#306
|
|||
|
|||
Is that a home brew cnc machine?
|
#307
|
|||
|
|||
Yes mate, it's wicked, he's built it all himself, it works a treat, considering I use real cnc mills all day at work, I prefer using his
|
#308
|
|||
|
|||
Well got a few jobs done this week, got my handbrake bracket fitted, really pleased with this as its held the cables dead in the right place
Decided on what switches I'm going to use for my dash, and got some switch guards, only thing there 4mm not 5mm so I think they will fail iva so I'm going to have to push some rubber tube over them I think Also made a mount for my wheel speed sensor, there was a spare hole on the engine so I used this, it's going to pick up off a long bolt on the prop adapter It sits closer than it looks, it's just the angle of the pic |
#309
|
|||
|
|||
|
#310
|
|||
|
|||
|
Thread Tools | |
Display Modes | |
|
|