|
|
#31
19th November 2009, 10:17 AM
|
||||
|
||||
Welcome to the forum
Welcome to the forum Enoch
 I see you have had plenty of sound advice already  The best option, budget wise, is to just use what comes from the donor. Sierra 1.8 CVH or the rarer Pinto will do just fine. Saloon,Hatch or Estate, all suitable. This will make sure that your nuts are preserved  Once she is hooked on the thrill...............Tap her up for a bigger one !!?? 
__________________
I am not a complete idiot...........Some of the parts are missing !! Ronnie www.roadster-builders.co.uk 
|
|
#32
20th November 2009, 09:47 PM
|
|||
|
|||
OK, so I am now actively looking for a Sierra, not found one yet but time is on my side. I have authorisation from swmbo (she who must be obeyed) only proviso being I have to sell one of my steam locos to pay for it all. Haven't touched the bloody thing for years anyway
The book is on order from Amazon, I have a mountain of welding rods, I have sourced about 40 metres of 25mm sq steel tube for just under an 'undred quid. Christ I must be going for it Got to get me garage roof fixed before I do anything, it is not what you might call water tight. Thanks to everyone for all the advise, having spent many hours on this forum it looks like there are some top blokes on here. It's so nice to see people exchanging ideas and giving time to their fellow builders. Regards to all, Enoch.
|
|
#33
20th November 2009, 09:53 PM
|
||||
|
||||
|
best wishes for your build,
don,t forget you,ll also need some 19mm box erw tube (most get 20mm box tube as its easier to get ), plus your CP plates its all in the book where abouts are you located ? might be a forum member close by. all the best andy
|
|
#34
20th November 2009, 10:02 PM
|
||||
|
||||
|
Hello mate,
You are flying along I am quite jealous,  The plan is to meet at the 3GE stand at 1pm. I am not wearing yellow but will be sporting an autumnal sun tan!! (Read the post Warning water is dangerous!!! By AshG) See you all tomorrow p.s. I bet you are up north, miles from me. OK right reply to the wrong question sorry
__________________
Sent from my iPad, from who knows where in the world I was building but I am not now! Build Pictures Build Thread Last edited by gingea1pom : 20th November 2009 at 10:18 PM. Reason: Trying to reply to to many posts
|
|
#35
21st November 2009, 10:16 AM
|
|||
|
|||
|
Hi Andy, yes I know I need 19mm, I thought I would get that a bit later. What are the CP plates? Not familiar with that - have seen them mentioned in several posts but don't know what they are. As for location I am in Bracknell Berkshire.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
