|
|
#1
4th September 2012, 11:06 AM
|
|||
|
|||
seat supports
I have bought some bars of steel to act as supports for my seats as I have an alloy floor.
Has anyone used the Kit parts direct GRP seats in their build. If so I am wondering where the supports need to be fitted. ie distance/spacing. My friend is coming around to fully weld my roll bar and re-inforce the diff support. I was hoping to have these supports in place as well. David
__________________
Click to see my build photos on Flikr http://www.flickr.com/photos/67112582@N03/ Saturn MX5 Based Chassis, Limited Slip Diff & 2.4 Quick Rack. Build cost.... seems to be spending more on tools than car bits at the moment! (they will be handy in the future though). Car iva'd and passed 15/08/2014. Finished weight 572kg. 
|
|
#2
4th September 2012, 11:50 AM
|
||||
|
||||
|
Your a million times better off getting all your components into the chassis and sitting in it. Get your driving position sorted before welding it together. Are you putting in seat sliders / adjusters?
__________________
Built/IVA'd Roadster - RS2000 16v, ZX6R, Megajolt
|
|
#3
4th September 2012, 12:52 PM
|
|||
|
|||
|
I will put an adjuster on the driver side. Im not going to on the passenger side to save a bit of weight.
__________________
Click to see my build photos on Flikr http://www.flickr.com/photos/67112582@N03/ Saturn MX5 Based Chassis, Limited Slip Diff & 2.4 Quick Rack. Build cost.... seems to be spending more on tools than car bits at the moment! (they will be handy in the future though). Car iva'd and passed 15/08/2014. Finished weight 572kg.
|
|
#4
5th September 2012, 09:11 AM
|
|||
|
|||
|
Having exactly the same thoughts - have also come to the conclusion that I need to place things in the chassis with me sitting in it to work out where they need to go...
__________________
http://meandthekitcar.wordpress.com/
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
