|
|
#1
12th July 2015, 08:44 PM
|
|||
|
|||
Sierra Lobro shafts
Well managed to get a bit done today, however I bit concerned about the assembly of the drive shafts. They are the lobro type with the 6 steel ball bearings in the cv cage.
I can get the thing assembled but there is very little movement, is this normal? I have trawled through Google but there is limited information/descriptions. Has anyone got any tips about the assembly? Thanks Managed to find a old thread on here with a Youtube link, I seem to be doing exactly as the vid but I ain't got any diagonal movement, just in/out. Last edited by NeilW : 12th July 2015 at 08:52 PM. 
|
|
#2
13th July 2015, 11:33 AM
|
|||
|
|||
|
Nip down to CPS on the valley and get them to do it for you,its locked up by the sound of it,they are a PITA to get right.
__________________
Cost : Little as possible. Thanks : To those who by their generosity my build has progressed. Its a handmade sports car not a flaming kit car !!! If at first you dont succeed,avoid skydiving... No parachute require to freefall,only if you want to do it twice.
|
|
#3
13th July 2015, 12:55 PM
|
|||
|
|||
|
Managed to get them stripped down again, trying to get my head around which way they go back together, there is a recessed line on one side of each cage not sure which way they should face?
Also just got some boots for them, so many different types etc hopefully I got the correct ones. They are bolt on type boots.
|
|
#5
14th July 2015, 09:38 AM
|
|||
|
|||
|
Stan at Drivelink does them with his eyes shut,proper pita.
__________________
Cost : Little as possible. Thanks : To those who by their generosity my build has progressed. Its a handmade sports car not a flaming kit car !!! If at first you dont succeed,avoid skydiving... No parachute require to freefall,only if you want to do it twice.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
