Harness mount bosses

[David_17]

Where's the best place to get some 7/16 threaded tube to weld into the roll bar to mount the harnesses?

Cheers

Dave

[Bonzo]

PM sent to you David

[james3004]

I Got mine From 3ge, but then that doesn't really help does it

[David_17]

Thanks guys.

[ginger nutter]

I am in need of some threaded tube for my upper harness mounts been searching but no joy, where are you guys getting them from?

[Bonzo]

As luck would have it, I recently spent a few days working on my lathe.

I have been utilising some of my surplus materials kicking about.

Just happen to have 4 sets of harness bosses up for grabs

They have been made from 19mm bright round bar & have been bored n threadded with the required 7/16" UNF thread, 50mm in length.

£7.50 per set inclusive of postage.

Drop me a PM if you are interested.

Failing that, try Saturn or Talonmotorsport, I am sure that either of them will be able to help out

[Davey]

PM sent . I could do with a set.

D.

[Bonzo]

Pm back at you Davy

[gaz05]

Do They have to be 7/16 UNF? I'd like to make my own but only have metric taps.

[Bonzo]

Hi Gaz

Strickly speaking no but they should ideally be threadded with a fine thread & metric fine threadded bolts are a real PITA to get hold of, not to mention expensive.

7/16" UNF bolts have been used for years & has more or less been adopted as the industry standard for seatbelts

If you buy a pair of harnesses new, they will most likely come with 7/16" UNF fixings ( Mine certainly did )

All is not lost mate.

You should be able to pick up a decent 7/16" UNF tap on ebay for not a lot of money

Hope that helps