#1
|
|||
|
|||
Opinion wanted on Flywheel
Hi all,
I have been reading up on the forum about connecting a 2ltr zetec engine (mine is a silver top) to a type 9 gearbox and the general concensus is the following: 1.8 ltr Zetec flywheel (because it is lighter) 1.8 mondeo clutch CT133 release bearing I have found the following flywheel on ebay Link Here Would this be a suitable for my intended application? Cheers in advance, Jonathan |
#2
|
||||
|
||||
1.8 flywheel is needed because its thinner than the 2L.
Type 9 bellhousings don't fit over a 2L jobbie (well some do, some dont) Your suggested setup there is the way to go. Not sure about that ebay one as I cant see the other side. |
#3
|
|||
|
|||
Cheers for that.
If I ask for a picture of the otherside, what is it that I am looking for to know if it is suitable? Cheers, Jonathan |
#4
|
|||
|
|||
1.8cvh fits im told and is lighter again but has no trigger teeth so you need to fit a trigger wheel
|
Thread Tools | |
Display Modes | |
|
|