|
|
#1
4th January 2012, 02:45 PM
|
||||
|
||||
Bonnet Edge Trim
Just wondered what edge trim folks are using on the front and rear of the bonnet where it meets the scuttle / nose cone?
Whilst I'm at it, when fitting the nose/bonnet/scuttle, do I start by fixing the nose in place, then let the bonnet decide where the scuttle ends up? 
|
|
#2
4th January 2012, 03:35 PM
|
||||
|
||||
|
I wondered this myself
 .I trial fitted the nose cone and bonnet.The scuttle only fits within a certain area and is governed by the trim fitted.From my research(looking on ebay) this varies from 8mm-14mm in depth .Hopefully this helps http://www.ebay.co.uk/itm/Car-Door-R...item27bb306407 http://www.ebay.co.uk/itm/VW-T1-T2-T...item33701b0145 http://www.ebay.co.uk/itm/RUBBER-BLA...em27b9bc bdcd Last edited by ozzy1 : 4th January 2012 at 03:37 PM.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
