|
|
#1
4th September 2016, 10:34 PM
|
|||
|
|||
Roadster Boot
Decided I needed a boot to keep a few bits in, including a tin of tyre weld! Just need to paint it now, but it's looking OK. This works with the MX5 back end, I am sure it would work for others also. Check out the pics,
https://www.flickr.com/photos/136904.../shares/H5kdHd 
|
|
#3
5th September 2016, 10:17 AM
|
|||
|
|||
|
Agreed,anyone not bothered to make one they are available from Plays-kool
for £95 inc vat.
__________________
Cost : Little as possible. Thanks : To those who by their generosity my build has progressed. Its a handmade sports car not a flaming kit car !!! If at first you dont succeed,avoid skydiving... No parachute require to freefall,only if you want to do it twice.
|
|
#5
6th September 2016, 10:07 AM
|
|||
|
|||
|
I agree,a lot of the stuff they do (don't) is supplied by other people.
__________________
Cost : Little as possible. Thanks : To those who by their generosity my build has progressed. Its a handmade sports car not a flaming kit car !!! If at first you dont succeed,avoid skydiving... No parachute require to freefall,only if you want to do it twice.
|
|
#6
6th September 2016, 10:06 PM
|
|||
|
|||
|
Fully finished.
https://www.flickr.com/gp/136904711@N05/2S0g11
|
|
#7
7th September 2016, 12:57 AM
|
|||
|
|||
|
I think that looks really well presented. Wouldn't mind the basic plans if you have them?
__________________
Total Spent so far - £xxxxx Last Purchase - Engine mounts, steering wheel, slave cylinder.
|
|
#8
7th September 2016, 09:55 AM
|
|||
|
|||
|
Nice job, well done, might try to do something like that on mine after IVA
__________________
My build blog here http://ianhaynes20.wordpress.com
|
|
#9
7th September 2016, 11:22 PM
|
|||
|
|||
|
No real plans unfortunately, I just measured up the space & went from there. It is about 7" deep, 7" wide & 14" long, ish!
I started with a flat piece of ally & cut it to size, I then cut the corners out which left me with a sort of cross shape, I then folded the sides up 90deg. I put some 90 deg angles in the cornerstone hold it all in place. The box was attached to the cover by more 90 deg angles. The cut out from the cover made the lid. I hinged mine at the back so I could open it past my roll bar. Nothing to difficult, just plenty of planning first!! Hope this helps
|
|
#10
8th September 2016, 01:05 PM
|
|||
|
|||
|
Cardboard template first then cut ally or whatever.
__________________
Cost : Little as possible. Thanks : To those who by their generosity my build has progressed. Its a handmade sports car not a flaming kit car !!! If at first you dont succeed,avoid skydiving... No parachute require to freefall,only if you want to do it twice.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
