|
|
#1
11th November 2012, 05:06 PM
|
|||
|
|||
Hoses
Hi all,
I'm about to start on my cooloing system. But i have a question, on my pinto water pump, there are two outlets one large and small. I know the large goes to the rad, but where does the other go to? Terry
__________________
If you need a friend, call me, if u need company call me, if you need help call me, if u need money this number is no longer available. 
|
|
#2
11th November 2012, 05:30 PM
|
|||
|
|||
|
Thats the return from the heater matrix.
Bob
__________________
When The Results Disagree With The Theory: Believe The Results And Invent A New Theory If I had two brains I,d still be a halfwit The cave http://s1116.photobucket.com/user/my...deshow/mancave The build http://www.haynes.co.uk/forums/showthread.php?t=12669
|
|
#3
11th November 2012, 07:44 PM
|
|||
|
|||
|
I take it i just blank it off then?
Thanks robo Terry
__________________
If you need a friend, call me, if u need company call me, if you need help call me, if u need money this number is no longer available.
|
|
#4
11th November 2012, 08:05 PM
|
|||
|
|||
|
I cant remember if the pinto has an internal bypass. if not you will have to loop it into the heater feed to for the bypass.
bob
__________________
When The Results Disagree With The Theory: Believe The Results And Invent A New Theory If I had two brains I,d still be a halfwit The cave http://s1116.photobucket.com/user/my...deshow/mancave The build http://www.haynes.co.uk/forums/showthread.php?t=12669
|
|
#5
11th November 2012, 08:39 PM
|
||||
|
||||
|
Mine goes from there round the back of the block to the inlet manifold.
If you plan on using no standard carbs then give ashg a pm or look on his pics to see what he did. HTH
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
