|
|
#1
6th May 2011, 02:14 PM
|
|||
|
|||
Brake pipe tab placement
Wheres the best place to put the little brake pipe taps on the chassis?
I'll be running drums on the rear. I think the book location for the fronts looks ok not sure about the rear, do I need a tab on the rear upright also? Mike
__________________
Build Cost so far £xxx (Given up adding it up) - She Starts!! Build Thread Here: http://www.haynes.co.uk/forums/showthread.php?t=5501 
|
|
#2
6th May 2011, 02:27 PM
|
||||
|
||||
|
dont bother with the fronts. they dont pass iva fix the flexis to the side panel and the copper on to the back at the front.
have a look at my photobucket for where i put the rear ones.
__________________
My Roadster Is Finished NerNer....... Pigs can fly, you just have to carry them onto the plane. My Pictures http://s707.photobucket.com/user/ashgardiner/profile/
|
|
#3
6th May 2011, 02:33 PM
|
|||
|
|||
|
Thanks ash I've looked in your photobucket but its vast so haven't found the right pictures.
__________________
Build Cost so far £xxx (Given up adding it up) - She Starts!! Build Thread Here: http://www.haynes.co.uk/forums/showthread.php?t=5501
|
|
#4
6th May 2011, 03:07 PM
|
||||
|
||||
|
Quote:
|
|
#5
6th May 2011, 04:21 PM
|
|||
|
|||
|
Quote:
|
|
#6
6th May 2011, 04:25 PM
|
|||
|
|||
|
Ally panels would be less flexible than glass and would be tempted to reinforce glass panel with ally at the rear of the panel and large washer at the front as Mark says with bulkhead fitting.
__________________
Cost : Little as possible. Thanks : To those who by their generosity my build has progressed. Its a handmade sports car not a flaming kit car !!! If at first you dont succeed,avoid skydiving... No parachute require to freefall,only if you want to do it twice.
|
|
#9
6th May 2011, 10:29 PM
|
|||
|
|||
|
Think we need some photo's of this.
I don't like the idea of fixing the piper to a thin side panel just doesn't seem right. surely if the tab is very close to teh side panel you wouldn't need a big hole. A few pictures might help or maybe I'm just being thick tonight 
__________________
Build Cost so far £xxx (Given up adding it up) - She Starts!! Build Thread Here: http://www.haynes.co.uk/forums/showthread.php?t=5501
|
|
#10
6th May 2011, 10:58 PM
|
|||
|
|||
|
Mike you are being THICK sorry..
...run your copper pipe up to a bulkhead fitting in the side panel then from that fitting you fix your braided(dont go using rubber jonny pipe pleeeease!!) hose down to your caliper
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
