|
|
#1
11th May 2010, 01:16 PM
|
||||
|
||||
Pedal box help.
While in the garage rummaging through the boxes of stuff that came with my chassis I found some odd pieces of steel. After getting my nose stuck into the book, I realised I had a complete pedal box kit, probably from 3ge. This will hopefully save me a few quid, but when I found the donor car's master cylinder it is far to big for the hole in the pedal box back plate. The question is, do I fettle the hole and make it bigger to take the master cylinder, or just buy a new master cylinder?
Is there any difference in the different size cylinders? Cheers Alan 
|
|
#2
11th May 2010, 01:20 PM
|
||||
|
||||
|
I had the same problem. If found both the the big hole and bolt holes were wrong. I think there are different size cylinders depending on exactly which sierra you had. I popped mine on my mill and bored the hole out. You could equally get a file and open it out.
__________________
Gallery 2 http://www.facebook.com/album.php?ai...4&l=a9831a9319 Gallery 3 http://www.facebook.com/album.php?ai...4&l=3f0d42c523 Gallery 4 http://www.facebook.com/album.php?ai...4&l=efb083b7df Gallery 5 http://www.facebook.com/media/set/?set=a.10150244028550325.366987.601005324&l=583fd5 cd3a Gallery 6 http://www.facebook.com/media/set/?set=a.10150550640070325.430417.601005324&type=1&l =fe779b358c
|
|
#3
11th May 2010, 02:13 PM
|
||||
|
||||
|
Cheers David
I thought it would be as simple as that, but wasn't sure. The hole is quite a bit out, so will probably have to mark out the hole and drill little holes all round on my pillar drill and file it down, wish I had the use of a milling machine, oh yeah, and the skill to use one  I reckon I must be the most unskilled person on here, can't weld, can't use a mill or laithe, it's going to be interesting when I eventually get round to starting.
|
|
#4
11th May 2010, 10:07 PM
|
||||
|
||||
|
CaptainCrash1971, you clearly haven't met me then! I've never welded a thing in my life - I struggled with soldering the last time I tried
 I'm just looking forward to the challenge of learning all the new skills 
__________________
David
|
|
#5
11th May 2010, 10:30 PM
|
||||
|
||||
|
I found this out too, I tacked a piece of angle iron across the hole, and made it larger with a hole saw.
|
|
#6
11th May 2010, 10:38 PM
|
||||
|
||||
|
Quote:
|
|
#7
11th May 2010, 11:45 PM
|
||||
|
||||
|
Quote:
Top tip SL I probably would have thought of that on the last stroke of 3 hours with a file 
__________________
I am not a complete idiot...........Some of the parts are missing !! Ronnie www.roadster-builders.co.uk
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
