#1
|
||||
|
||||
Build Update
Well after I decided to write off the ZVH off and go the zetec route it's finally in
Bit of a squeeze, tho had to remove one of the top chassis rails in the engine bay and the inlet touched the steering column But after a bit of fettling hopefully there is enough clearance now! This arrived today as well! |
#2
|
||||
|
||||
The car is now painted in primer
|
#3
|
||||
|
||||
nice work James .....pleased to see someone else taking the charge cooler route, you wont regret it as it will bring the charge temps way down, much more efficient than a air/air jobby (much smaller too)
|
#4
|
||||
|
||||
Nice one James. What colour did you decide on?
|
#5
|
||||
|
||||
After lots of deliberation over different colours I have gone for the old favourite......white!
|
#6
|
||||
|
||||
|
#7
|
||||
|
||||
|
#8
|
|||
|
|||
Nice trim job what are your internal side panels made of that you have attached the material to
Arfon |
#9
|
||||
|
||||
Looking good mate, must be nearly done if you're trimming the interior
|
#10
|
||||
|
||||
Slowly getting there John any news on your bodywork?
I used 1" foam from dunelm to fill in between the box section and then just carpeted over it Last edited by james3004 : 20th August 2014 at 11:48 AM. |
Thread Tools | |
Display Modes | |
|
|