|
|
#1
22nd April 2011, 06:21 PM
|
|||
|
|||
steering column bush kit
Hi I have a bit of an issue I went searching for the steering column bush kit everywhere and I'm not able to find it I did ask a company that does sell them If I could buy from them they said they had no stock but I'm not sure if that's the truth cause some people have complained about them cause there service is bad they seem to not want to deal with anyone if you have not bought there chassis and few people have told me that they have been rude to them so I need some help with the steering bush kit is there an alternative way of working around this or what can I do does anyone have any advise for me please
|
|
#2
22nd April 2011, 06:43 PM
|
||||
|
||||
__________________
You only get a woosh with a dump valve Build Thread Man Cave Mantiques Cecil Street Auto Repairs Garage Carlisle Build Cost £4181.65 - Last - Wheel Cylinders
|
|
#4
22nd April 2011, 07:39 PM
|
||||
|
||||
|
Ditch the original, there is too much play within time.
Get one of these but you will need the part the goes on the triangular part of the shaft to change it to round. Its the top bit in this pic: 
|
|
#6
22nd April 2011, 08:37 PM
|
||||
|
||||
|
Yes,
Here is a pic of ash's. It is positioned inside the drivers footwell as during iva he got asked to move it. I'm not sure what test you have to go through in SA. 
|
|
#7
22nd April 2011, 08:46 PM
|
|||
|
|||
|
steering column bush kit ?
I see what you mean but I still have to get that plastic thing from the uk well the whole steering column bush kit cause I can't get it here and please tell me that steel one were can I get one and does it come of any car or what ?
|
|
#8
22nd April 2011, 09:35 PM
|
||||
|
||||
|
I'm not Too sure if you can get it in SA, it's not from a car it's just an industural bearing. Have a google the codes that are in the eBay description and you may be able to find it.
|
|
#9
22nd April 2011, 09:43 PM
|
|||
|
|||
|
steering column bush kit
Oh ok do you perhaps know the name of it or how can I find it on ebay and tell me that plastic part that I need to use would it not be ok if I made one if I ha the dimensions?
|
|
#10
22nd April 2011, 09:56 PM
|
||||
|
||||
|
The link to the bearing is in my 1st reply and the one to the plastic bit is in the one from twin turbo.
More info on the bearing
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
