|
|
#2
1st April 2011, 08:56 PM
|
||||
|
||||
I cut all the crap off mine. It seemed to have alot of plugs that weren't even in use, as if they make the same loom for all cars regardless of spec.
|
|
#3
1st April 2011, 09:02 PM
|
||||
|
||||
|
Bin the lot in my opinion.
The engine loom can stay in one bit, but just cut off the 8(9) plugs you need to keep for the roadster 3x Plugs to engine loom Ingniton loom plug horn slip ring plug dash plug (if using sierra dash) Left lighting stalk plug Right lighting stalk plug Brake Resv Plug Think that's it. TT
__________________
You only get a woosh with a dump valve Build Thread Man Cave Mantiques Cecil Street Auto Repairs Garage Carlisle Build Cost £4181.65 - Last - Wheel Cylinders
|
|
#4
1st April 2011, 09:26 PM
|
|||
|
|||
|
I found it easiest to make my own loom but retaining the engine / ecu wiring. There are not many circuits needed, from the front to the back of the car you need side lights, left indicator, right indicator, reverse, fog, fuel pump, brake and 2 wires for the fuel sender. At the front you have the hi and low beam, sides, left and right indicators, horn and fan. You need relays for fan, horn, hi and low, also a flasher / hazard relay. You need to wire up your dash but that's just "tapping in" to the circuits already mentioned plus a couple of wires for temp and alternator. I think it would have taken ages to cut out all the unwanted circuits and to trim down the wires that would be left.
Just my 2p worth.
|
|
#5
1st April 2011, 09:49 PM
|
|||
|
|||
|
After spending a full day trying to sort out a Sierra loom to use only the engine sensors and starting and charging to use on the race car I am building I took a complete wobbler and ripped it out to replace it with a purpose made one,neater,easier and much more usefull.
__________________
Cost : Little as possible. Thanks : To those who by their generosity my build has progressed. Its a handmade sports car not a flaming kit car !!! If at first you dont succeed,avoid skydiving... No parachute require to freefall,only if you want to do it twice.
|
|
#6
1st April 2011, 11:03 PM
|
|||
|
|||
|
I'll be using the Sierra loom with a Mondeo engine loom spliced in for the Zetec engine. My reason for using it is to keep the wiper and heater/blower circuits in case I put a hood on it.
__________________
Total cost so far Materials £3,150 Tools £855
|
|
#8
2nd April 2011, 11:29 AM
|
||||
|
||||
|
Have fun getting it all out, feeding it thru from the engine and then out the fuse box hole is fun!
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
