Front upper wishbone jig

[martin62]

Hi can someone help I was makine my front upper wishbone jig today and was trying to find a measurment for the 2 front 25x6 angled brackets.what I am looking for is the lenght of the front edge which is on 5.12 on page 63. Otherwise had a good day got all my front suspension brackets lined up and tacked up 7.30am start and had a very nice visit from transverse which was great having someone likeminded to chat too.

[Bonzo]

That measurement can be nicked from the drawing on page 61.

The length is given as 236mm to the centre of the wishbone bush tube

So 236mm + half the width of the bush tube. On the book spec tube, this is approximately 17mm .... Unless you have a tape measure that has fractions of a mm graduations on it

I make the overall length of the upper front wishbone 253mm.

[martin62]

Originally Posted by Bonzo

That measurement can be nicked from the drawing on page 61.

The length is given as 236mm to the centre of the wishbone bush tube

So 236mm + half the width of the bush tube. On the book spec tube, this is approximately 17mm .... Unless you have a tape measure that has fractions of a mm graduations on it

I make the overall length of the upper front wishbone 253mm.

Hi Ronnie sorry if I was not clear in my question but I ment the height of the 2 angled pieces that are set at 98 degrees thanks Aidan