|
|
#1
12th June 2013, 12:43 PM
|
||||
|
||||
Sump plate and gaskets
I shortened my oil sump, and then I made sump plate (tu keep oil near shortened oil pick-up).
And the question is... should I use two OEM gaskets between oil sump/plate/engine or just use "rubber-gasket" silicon adhesive ?  
__________________
Lucas ZX9R BEC Haynes Roadster - build cost so far: £1125 My build thread "Whatever you can do or dream you can, begin it. Boldness has genius, power, and magic in it." J.W.Goethe Last edited by loony : 12th June 2013 at 03:43 PM. 
|
|
#2
12th June 2013, 08:33 PM
|
||||
|
||||
|
Hi,
Personally, I hate this silicone adhesive. Might be ok for repairing, but for a full sealing, I would definitely use 2 original gaskets. But it is just my humble opinion  Good luck!
__________________
Sylvain Pictures of my completed Roadster https://www.flickr.com/photos/994983...7646799525542/ Build blog: http://vouchtroadster.blogspot.se/ https://cafrazx550.blogspot.com/
|
|
#3
12th June 2013, 08:40 PM
|
||||
|
||||
|
I've heard that now even manufacturers use RTV silicone instead of a sump gasket. I tried using the CVH 1.8 gasket with my CVH sump, but that didn't work very well, and now my sump is glued with silicone.
__________________
Albert Haynes Roadster FAQ | Haynes Builder Locations Gallery, build thread in Lithuanian / via Google Translate.
|
|
#4
13th June 2013, 08:13 PM
|
|||
|
|||
|
VAG silicone/PSA citroen peugeot from dealers is expensive but works well.
__________________
Cost : Little as possible. Thanks : To those who by their generosity my build has progressed. Its a handmade sports car not a flaming kit car !!! If at first you dont succeed,avoid skydiving... No parachute require to freefall,only if you want to do it twice.
|
|
#5
13th June 2013, 08:54 PM
|
||||
|
||||
|
Würth also make high-temp, oil resistant silicone. Oil pans are listed on the list of intended applications.
http://www.camskill.co.uk/m1b0s4322p...Black_-_200ml_ miska olejowa :http://www.wurth.pl/katalog2/karty/A0890%20320.pdf
__________________
Albert Haynes Roadster FAQ | Haynes Builder Locations Gallery, build thread in Lithuanian / via Google Translate.
|
|
#6
13th June 2013, 09:16 PM
|
|||
|
|||
|
I had to change the main bearings in my puma 1.7 vct, and ford state that its a paste (silicon) gasket. The mechanic at ford said that the best one on the market was the one from Nissan dealers. I have used this many times, and it has been absolutely brilliant, never an issue. Quick warning, don't get any on your clothes, because it doesn't come out, took my top off after using it, chucked it into washing basket on wife's new jeans, to say that she was a little grumpy when she had to throw them out was a little left of the truth.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
