![]() |
#1
|
|||
|
|||
![]() After leaving my build in the garage for over 18 months, I'm trying to get my backside in gear and make some more progress on it
![]() Currently looking at the front suspension, where I'm using MX-5 NB uprights and original SSC spec wishbones (M14 x 1.5 threaded inserts). I'm trying to source a suitable ball joint to connect the upper wishbone to the upright. If I was using a NA upright, I could use the BMW 7 series track rod end that SSC suggested. However, the upper mounting point on a NB is significantly thicker than an on the NA upright, meaning that the BMW TRE is really too short (I've mocked it up on the car as I already have the BMW TREs). Has anyone come across an alternative ball joint that will fit the NB upright taper and have a M14 x 1.5 RH thread? Ta. |
Thread Tools | |
Display Modes | |
|
|