what mm ali to use?

[layotn20]

what mm ali is acceptable for, floor/transmission tunnel/ and back seat part. 1.2mm or 2mm?
using the fiberglass pannels for the rest

[Tilly819]

i think i used 1.6 for the floor and 0.9 every were elce

tilly

[layotn20]

cheers mate

[Tilly819]

also i think iv used 1/8th pop rivets on a 2 inch pitch

tilly

[deezee]

Remember that aluminium comes in many strengths and grades and you can get a 1.2mm sheet that is harder than a 2mm sheet

For rivet spacing, 10 times the rivet width is a reasonable rule of thumb.

[layotn20]

Originally Posted by deezee

Remember that aluminium comes in many strengths and grades and you can get a 1.2mm sheet that is harder than a 2mm sheet

For rivet spacing, 10 times the rivet width is a reasonable rule of thumb.

what grade and mm, would you recomend for floor and rear seat section? im just gona do it with the same alli saves buying different sheets?