|
|
#1
21st July 2015, 01:00 PM
|
|||
|
|||
Rear disk brakes
Back again with further woe's!
Just fitting my rear disk brake assembly (Sierra) and noticed that I don't have the splash cover/backing plate. Is this a critical requirement? Currently I have a load of free play in the driveshaft through the upright but I think this is due to not tightening the 36mm lock nut yet...still waiting socket from the bay. Reading up about the backing plate there are a few comments saying people run without them but I am not sure for Iva. As usual they are like rocky horse **** to get hold of.
__________________
Total Spent so far - £xxxxx Last Purchase - Engine mounts, steering wheel, slave cylinder. 
|
|
#2
21st July 2015, 03:05 PM
|
||||
|
||||
|
I didn't fit dust guards to any of my hubs, I recon it just means more cleaning back there really. Passed IVA like that.
Cheers Stot
__________________
1.6 Mazda B6 : Garrett TBO339 : 420cc WRX Injectors : FMIC : Microsquirt V3 : LC-2 Wideband : Toyota COP : 1.8 ATB LSD Build Started Jan 2013 : OTR Aug 2014 : Still OTR June 2024 Last edited by Stot : 21st July 2015 at 05:49 PM.
|
|
#3
21st July 2015, 04:13 PM
|
|||
|
|||
|
If you are around Dunston at all call in and I can stick the air gun on them for you if you don't get sorted.
__________________
Cost : Little as possible. Thanks : To those who by their generosity my build has progressed. Its a handmade sports car not a flaming kit car !!! If at first you dont succeed,avoid skydiving... No parachute require to freefall,only if you want to do it twice.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
