rear uprights with disks

[Talonmotorsport]

I'm making some rear uprights to suit the disk set up but can't remember what side the caliper goes on (parts where removed over 5 years ago) I don't think it makes a difference but as there not mine I'd rather check first.

[Ricky]

hi can someone please help me with some info i just wanted to find out about part RU7 does it fit flush with the top of the steel pipe and does its get welded onto the steel pipe with the lines in line with the holes part RU8 so could anyone help me please

[Talonmotorsport]

I ground a 5mm weld prep around the outside edge of RU7 welded it completly, ground it flush then welded RU8 to both RU7 and the 5 inch tube. The edge of RU7 sits flush with the top of the tube and the holes in it are for clearance of the bolts, I'd put some spare M10 bolts in the tapped holes to stop any weld spatter going in and causing problems later.

[RAYLEE29]

Hi, my calipers are set at 45degrees rearward, there are previous posts about this.
Ray

[Talonmotorsport]

Would that be at 45deg up at 10:30 or 45deg down at 7:30?

[RAYLEE29]

up at 1.30 Passenger side 10.30 driverside or 45 degrees rearward from top 12 o clock
Ray

[Bonzo]

I would imagine that it is 45% Whatever time of day you make them

I'll get my coat

[RAYLEE29]

Chuckle