![]() |
|
#1
|
||||
|
||||
![]() Welcome Gary the cooper....was'nt he a film star
![]() |
#2
|
|||
|
|||
![]() Welcome to the forum Gary, Rally Design do some really good deals, just bought a set of Gaz coilovers for £380 including springs & shipping. Very impressed ! Phil of Talon Motorsport on this forum does loads of fabricating work, the mx5 engine mount brackets are a must, makes the job a lot easier, then we have K4kev , he is the fuel tank guru. There are some really clever people on here, handy to know. Don't ask me anything, I am learning as I go ! Lol
![]() ![]() |
#3
|
||||
|
||||
![]() Word or warning: your headlight stalks seem to be on the long side. Mine are shorter and I'm thinking of shortening them still, because the lights impact the cycle wings on full lock and suspension compression. The nose cone does not project outside the top chassis rails, so you you can judge the gap there by offering a cardboard cutout of your chosen headlight size or just measuring the distance between the headlight mounting hole and the top chassis rails. As for the 400 mm maximum dimension between the side of the car and the edge of the headlight, just remember that the widest point of the car is at the rear arches and it is 169-170 cm depending on your tub and wings. You can work out the minimum distance between the light mounting holes based on that width and the size of your lights.
Update: that said, I positioned the bulge of the cycle wings right beside the headlight, so you might be fine: ![]()
__________________
Albert Haynes Roadster FAQ | Haynes Builder Locations Gallery, build thread in Lithuanian / via Google Translate. Last edited by alga : 29th June 2014 at 10:39 PM. |
#4
|
|||
|
|||
![]() hi many thanks for that I will do some measuring and adjust as needed, I'd rather cut them now if I need to !
![]() |
#5
|
|||
|
|||
![]() hi been busy at work but took home the heavy mob today and trina fed them in exchange for putting my engine and box in ! seriously picked it up and said where do you want it?
end of box was still full of oil though so while I swept up they had coffee. at least now I can get engine mounts made up and crack on again. Gary ![]() http://www.haynes.co.uk/forums/attac...d=140614312 6 |
![]() |
Thread Tools | |
Display Modes | |
|
|