![]() |
#41
|
|||
|
|||
![]() Painted my vice
![]() and built a bench ive always wanted a steel bench ![]() Vice on bench ![]()
__________________
Slowly tipping over the edge into madness |
#42
|
|||
|
|||
![]() Then i got working on on the transmission tunnel
![]() ![]() ![]() Most of the tunnel tacked in place
__________________
Slowly tipping over the edge into madness |
#43
|
|||
|
|||
![]()
__________________
Slowly tipping over the edge into madness Last edited by SteveH1 : 1st November 2015 at 09:17 PM. |
#44
|
|||
|
|||
![]() Got a bit done on the rear suspension this weekend
![]() ![]() Also got my first chassis plate cut ![]() And my beautiful distraction ![]()
__________________
Slowly tipping over the edge into madness |
#45
|
|||
|
|||
![]() So i was given this roll bar its a standard caterham 7 bar
![]() ![]() ![]() So my plan is to cut off the original mountings on the thick bar and put a flat bar plate on each end. Then make a plate the same as cp3 and cp4 and mount them 50mm higher straight above cp3 and cp4 with nuts welded on the inside Like build a box if this makes sense 50mm high can anyone see a problem with this Can i then weld 50mm box section between these boxes with the seat belt anchorage's welded into this bar
__________________
Slowly tipping over the edge into madness |
#46
|
|||
|
|||
![]() Ok so im not sure what to do about the roll bar
so i started making some of the chassis plates and despite what people were saying about just buying them laser cut i actually found the fabrication of these plates very rewarding and satisfying maybe its because there is a bit more work involved or maybe its because i saved money who knows. so i got these drill bits a while ago its amazing the difference a good drill bit makes ![]() i also got these during this week ![]() ![]() m18x2.5 bar
__________________
Slowly tipping over the edge into madness |
#47
|
|||
|
|||
![]() So not sure what to do About the roll bar so when making cp3 and cp4 i cut the roll bar end plates and drilled them on top of each other so they are an exact match
![]() both plates drilled ![]() both plates nuts welded ![]()
__________________
Slowly tipping over the edge into madness |
#48
|
|||
|
|||
![]() ![]() ![]() ![]()
__________________
Slowly tipping over the edge into madness |
#49
|
|||
|
|||
![]() If you have the means to do it,cut a hole in the roll bar plates and put roll bar through it and weld it,it will pull like a bast*rd when you do weld it
__________________
Cost : Little as possible. Thanks : To those who by their generosity my build has progressed. Its a handmade sports car not a flaming kit car !!! If at first you dont succeed,avoid skydiving... No parachute require to freefall,only if you want to do it twice. Last edited by flyerncle : 16th November 2015 at 04:49 PM. |
#50
|
|||
|
|||
![]() Quote:
and surley welding it to a flat plate would be better than a plate with a big hole not really sure what you mean
__________________
Slowly tipping over the edge into madness |
![]() |
Thread Tools | |
Display Modes | |
|
|