Haynes Forums

Haynes Forums (http://www.haynes.co.uk/forums/index.php)
-   Bodywork and interior (http://www.haynes.co.uk/forums/forumdisplay.php?f=8)
-   -   Aerocatches (http://www.haynes.co.uk/forums/showthread.php?t=4928)

davidimurray 4th September 2010 08:42 PM

Aerocatches
 
Has anyone used any of these with a saturn bonnet? If so have you used the flush fit or exterior mounted ones?

Deanno 4th September 2010 09:13 PM

I was planning on using the locking ones but not sure about IVA?

davidimurray 5th September 2010 04:49 PM

According to IVA, if the projection sticks out less than 5mm then the edges need to be blunted. According to the aerocatch drawing - http://www.aerocatch.com/updoc/Tech_...flush_dims.pdf if you use the ones that mount externally then they only stick out 2.5mm so should be ok.

The flush mount ones need a bonding plate so the bonnet would need to be less than 2.5mm thick.

james3004 6th September 2010 09:00 PM

I pesonally think the top mounted ones would look better, but I think you need 2 sets to secure the bonnet properly?

I have been looking for an alternitive the the rubber things, they look awful

SeriesLandy 6th September 2010 09:58 PM

I bought a set of the flush but havnt fitted them yet. Bro in law bought a set of plus flush for his mini boot but they don't look as good ( he's not as precise as me)

The Westfield kit uses a pin to locate the front so you only need a pair.


All times are GMT +1. The time now is 07:12 PM.

Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.