Haynes Forums

Haynes Forums (http://www.haynes.co.uk/forums/index.php)
-   Running gear (http://www.haynes.co.uk/forums/forumdisplay.php?f=5)
-   -   Help with Brake lines (kit spares) (http://www.haynes.co.uk/forums/showthread.php?t=7351)

Andy_B 31st October 2011 10:29 PM

Help with Brake lines (kit spares)
 
Am looking at these brake lines http://www.kitspares.co.uk/shop/item...=5005&catsub=0 but they seem to have 10mm x 1 male ends on each side ? the only bulkhead fittings i can find are both male ends..i have my brackets welded in position as per the book .. am running discs on the rear so was going to do a short run of copper from the caliper to another bracket i will weld onto the upright then the flexi to the chassis bracket...anybody done this and has some pics i can have a look at ?

Wgroove 1st November 2011 07:47 AM

Hi Andy, i also have the same from Kitspares.
I also welded a bracket on the rear upright, and used a short piece of copper pipe.
I dont have a picture of it, but check out the album of David Murray.
You will find a picture in his gallery 3, i also used his picture as an example.
http://www.haynes.co.uk/forums/member.php?u=1140

Regards,

Wim


All times are GMT +1. The time now is 10:36 PM.

Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.