Quote:
Originally Posted by davidimurray
John
For your Pinto flanges what size are the inlet/exhaust hole? I was looking at getting mine cut to the same size as the port +1.5mm to allow for tube thickness. Are the exhaust ones cut to the square profile? Also do you include a hole for the water take off point on the head to the carbs. I'm not planning to use this so wouldn't want it on the flange.
Cheers
Dave
|
Hi David,
Are you planning on puttnig the tubes inside the flange then? We can supply the hole sizes to suit this or to suit the tube welded on the plate. The exhausts are square in profile. We don't add the water take off point.
Kind regards
John