Quote:
Originally Posted by RAYLEE29
Ok.
But I do think you will have probs with the float height if you run at the wrong angle.
If you make the hose too long the carbs try to pop off when idling as it gets sucked in by vacuum also by having a long length of tube you create bad flow at the carb mouth you should aim to only have a couple of mm between the carb and runner
Might be a good idea to add some tube to the middle runners so they end up the same length
and bare in mind the float height if you cant get it to idle properly
Ray  |
Thanks for the advice
i will try and modify it to suit, as you may of guessed bike carbs are not my strong subject and only know what i have read on the internet. Are all bike carbs set at a similar angle or is it specific to make and model? I will try and angle them as much as poss within the clearance i have. Do you know what the optimum angle is?
Thanks