Quote:
Originally Posted by Andy_B
Andy...that tip to remove the flat worked a treat ....dead giveaway when i de-tacked it and saw "REMOVE" written on it !!! i am a diddy....have another question ...i have assembled and tacked on the rear frame...i have a spirit level accross RS6 comparing it with the spot on SB6...RS6 is down on one edge about 2mm (bubble touching left line)...how exact does this need to be ?
Thanks again
|
no worries about the "Remove" instruction, glad it sorted the problem.
Sorry for late reply on this, been mega busy.
If the rear frame is just tacked, if poss try & "tweek" it so that you get it as level as possible, maybe wedge something underneath it resting on the build table to keep it level whilst you weld it, but make sure if doing that it doesn,t throw the other side out.
Personally I would try & get it spot on if you can, are you sure its the frame & not the build table dipping slightly on that side?
cheers
andy