Quote:
Originally Posted by Johno
Hi all,
Well it's been some time since I've updated my build so had a chance today to take some photos.
Came up against a little problem as I made my bottom wishbones a little too long for the MX5 build from Saturn. As I had already finished and painted my wishbones I was a little reluctant to cut them up, so I decided to design my own top adjustable wishbones and make them easier to adjust on the car in situ.
Hopefully this will cure the problem but if anybody can see a problem please let me know. 
Here's a photo....
Well got more to come but will update when I get time....
Johno |
How much would you charge to make me a set of them? I've kind of hit a similar issue.
Basically I could only fit the rear pass side hub to the wishbones by putting about 10˚ of camber into it. Seems the driveshaft (halfshaft) is pushing the the hub too far out. also noticed that when lifting the hub it was stopped from travelling up by the driveshaft which then bounced the other hub up so something is not right. Seems I may need to think about moving the diff slightly. Took loads of measurements to see where I went wrong but can't real account for this issue using measurements alone!
http://www.haynes.co.uk/forums/showt...1417#post71417
EDIT: It's ok I found out what the issue was this morning.