|
|
#1
1st January 2011, 08:26 PM
|
||||
|
||||
Crush tube length
All pretty sure on this but just checking crush tube length is 35mm? didn't know if it should sit marginally proud or recessed.
Sorry for the DAQ  Rapid 
|
|
#2
1st January 2011, 09:06 PM
|
||||
|
||||
|
Just to be clear the crush tube is the part that goes inside the polybushes, has the bolt pass through it and gets clamped by the suspension bracket. This part should be stainless steel and 44mm long. The 33.7 OD bush tube that the poluybushes go in are 35mm long.
__________________
Website http://www.talonmotorfabrication.co.uk/ Direct email phil@talonmotorfabrication.co.uk talonmotorfabrication@gmail.com Mobile office hours 07514098334
|
|
#3
1st January 2011, 09:11 PM
|
||||
|
||||
|
Thanks for clarifying, much appreciated!
Rapid
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
