|
|
|
|
#1
30th April 2011, 09:15 PM
|
|||
|
|||
seat fitment
how does everyone fasten there seats to the chasis i'm not using runners so was just thinking of welding brackets straight onto chasis is this considered to be okay
Thanks
__________________
Richard Just keep going we will get there in the end. 
|
|
#2
30th April 2011, 09:20 PM
|
||||
|
||||
|
i just welded two 3.5mm straps from the top of the outer rails to the top of the tranny tunnel rails and bolted the seats to them with m10 bolts and big washers. Can jump up and down on them and theres no movement whatsoever.
__________________
A few build photos... www.photobucket.com/ntsengineering
|
|
#3
30th April 2011, 09:43 PM
|
||||
|
||||
|
I welded in 2 bits of 25mm box across the gap between tranny tunnel and outer rails. On the passenger side, using runners on the drivers
|
|
#4
1st May 2011, 12:10 AM
|
|||
|
|||
|
same here two bits of 25mm box per seat havent got runners yet but took the measurement every one uses from the metro seat runner combo
i best find some metro seat runners really ! 
__________________
theres a box ! im not allowed in it ! i have to think outside ! 
|
|
#5
1st May 2011, 08:35 AM
|
||||
|
||||
|
25mm Box and runners.
It's in my build thread. TT
__________________
You only get a woosh with a dump valve Build Thread Man Cave Mantiques Cecil Street Auto Repairs Garage Carlisle Build Cost £4181.65 - Last - Wheel Cylinders
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
