![]() |
|
#1
|
||||
|
||||
![]() What kind of tolerances have people built their chassis's to?
I've started bracing up my chassis with the 19x19mm tube and with DR5/6 (possibly), 1 side is about 3-4mm longer than the other. Im not entirely sure why, im going to go back in there later on to try and find out why. If i were to just make 1 of the pieces 3-4mm longer to fit perfectly in the gap would it be a big no no? If i were to just to do that, what issues might it cause? Cheers
__________________
1.8 Silvertop Zetec (ZX6R Carbs + Megajolt) + Type 9 My Build Blog: http://www.haynes.co.uk/forums/showthread.php?t=2736 - Last Update: 31st October 2020 Total Spent so far: Stopped counting ![]() |
Thread Tools | |
Display Modes | |
|
|