Tolerances - Haynes Forums

		Haynes Forums > Haynes Roadster Forums > Chassis
Tolerances

Thread Tools

Display Modes

2nd October 2009, 11:55 PM

jasongray5 jasongray5 is offline

Senior Member

Join Date: Feb 2008

Location: Western Australia, Home is Devon

Posts: 354

I would have a check that your bottom rails are all square mate. if i remember right, my chassis was all about 1-2mm within tolerence throughout?

HTH Jas

__________________
http://www.flickr.com/photos/3326151...7611049241239/

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

All times are GMT +1. The time now is 12:17 AM.