MX5 Diff Washer

[Johno]

Hi Ozzy1 and Skov,
Their the ones John, I meant to post a photo of them but you beat me to it. I've welded a bracket to my diif mounting plates to pick up the holes for the metal plate on the washer. I've tried to source new ones but had no luck as mine look a bit tired to say the least.
Well John how's your build going not seen too many photos lately.

Had a bit of an issue with Lukes rear suspension geometry Saturday as he mocked up his rear wishbones and wheel and found there was no adjustment left on the lower wishbones with the half lock nut in place. The camber adjusters were fully wound in and the wheel was still pointing outwards at the bottom...
Guess we are going to move the hole on the top wishbone and cut off the 30mm threaded bar pretruding on the back of the lower wishbone as well....hmmmm

How's yours looking ?


http://s1199.photobucket.com/albums/...1/MX5%20Build/

Bye Johno