Not quite a build thread....

[Johno]

Hi,
Hello John.... Not OCD I'm afraid just too much time on my hands....
Yellow looks nice from a photo but in reality I wasn't happy with the finish as I didn't origionally put enough down so I thought once everything was mocked up I'd put down a heavier coat once I rubbed it down.
Lot happier with the finish now almost like powder coat....


Well with regard to the ISCV take off I was thinking of using a "Revotec Self-sealing Hose Fittings - For Water / Air Hoses" in 19mm and place it between the throttle body and air flow meter hose using silicone hose elbow somehow. Do you see a problem with that?

In the worrkshop manual it states it controls "Bypass air amount". I guess it checks the amount of air flow before and after the throttle body sensor.
I'm not upto speed on the MX5 (or any other car for that fact) so I was hoping this was going to be OK...

Hi Wgroove,
Thanks for that. I'm using three ply polyester reinforced silicone hose used for cooling or air systems. It's a bit decieving in the photo as the top coolant hose is two pieces but as yet I haven't fitted my hose clips so it looks as though it is one piece. Hopefully the rest of my order will turn up soon so I can finish it and post a piccy.

Well I hope I've been of some help ...Johno